IJIEPR                   Back to the articles list | Back to browse issues page

XML Print


1- Department of Mechanical Engineering, Tabriz University, Tabriz, Iran.
2- Department of Mechanical Engineering, Tabriz University, Tabriz, Iran. , mrshabgard@tabrizu.ac.ir
Abstract:   (55 Views)
In this study, the electrochemical machining (ECM) of the 304 stainless steel with the response surface methodology (RSM) approach for designing, analyzing and mathematical modeling was used. The electrolyte type, concentration and current parameters were considered as the machining parameters. The mathematical model for the responses was presented and based on the type of electrolyte including NaCl, NaNO3 and KCl. The results showed that the current has the highest effect on Surface Roughness (SR) and Material Removal Rates (MRR) and respectively it improves them to 0.465μm and 0.425gr/min. The electrolyte concentration has the highest effect on Over Cut (OC) and causes to increase its values. Under the conditions of NaCl electrolyte, 1 molarity concentration and 55 A current, the optimum condition 0.4006 gr/min MRR, 0.75 mm OC and 0.465mm SR was achieved. 
Full-Text [PDF 661 kb]   (15 Downloads)    
Type of Study: Research | Subject: Manufacturing Process & Systems
Received: 2019/11/16 | Accepted: 2020/08/31

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


© 2020 All Rights Reserved | International Journal of Industrial Engineering & Production Research

Designed & Developed by : Yektaweb