جلد 32، شماره 2 - ( 3-1400 )                   جلد 32 شماره 2 صفحات 0-0 | برگشت به فهرست نسخه ها


XML English Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

El-Mahalawy M, SAMUEL M, Fouda N, El-Bahloul S. Investigating the Effect of Wire Electrical Discharge Machining Factors for Ductile Cast Iron (ASTM A536). IJIEPR 2021; 32 (2)
URL: http://ijiepr.iust.ac.ir/article-1-1120-fa.html
Investigating the Effect of Wire Electrical Discharge Machining Factors for Ductile Cast Iron (ASTM A536). نشریه بین المللی مهندسی صنایع و تحقیقات تولید. 1400; 32 (2)

URL: http://ijiepr.iust.ac.ir/article-1-1120-fa.html


چکیده:   (2488 مشاهده)
Abstract: Wire Electrical Discharge Machining (WEDM) is a non-traditional thermal machining process used to manufacture irregularly profiled parts. Machining of ductile cast iron (ASTM A536) under several machining factors, which affect the WEDM process, is presented. The considered machining factors are pulse on time (Ton), pulse off (Toff), peak current (Ip), voltage (V), and wire speed (S). To optimize the machining factors, their setting is performed via an experimental design using the Taguchi method. The optimization objective is to achieve maximum Material Removal Rate (MRR) and minimum Surface Roughness (SR). Additionally, the analysis of variance (ANOVA) is used to identify the most significant factor. Also, a regression analysis is carried out to forecast the MRR and SR dependent on defined machining factors. Depending on consequences, the best regulation factors for reaching the maximum MRR are Ton = 32 μs, Toff = 8 μs, Ip = 4 A, S = 40 mm/min. and V = 70 volt. Whereas, the optimal control factors that achieve the minimum SR is Ton = 8 μs, Toff = 8 μs, Ip = 2 A, S = 20 mm/min, and V= 30 volt. It is hypothesized that the perfect combination of control factors that achieves minimum SR and maximum MRR is Ton = 8 μs, Toff = 8 μs, Ip=5 A, S=50 mm/min. The microstructure of the machined surface in the optimal machining conditions shows a very narrow recast layer at the top of the machined surface.
     
نوع مطالعه: پژوهشي | موضوع مقاله: Optimization Techniques
دریافت: 1399/7/4 | پذیرش: 1400/3/29 | انتشار: 1400/3/29

ارسال نظر درباره این مقاله : نام کاربری یا پست الکترونیک شما:
CAPTCHA

بازنشر اطلاعات
Creative Commons License این مقاله تحت شرایط Creative Commons Attribution-NonCommercial 4.0 International License قابل بازنشر است.

کلیه حقوق این وب سایت متعلق به نشریه بین المللی مهندسی صنایع و تحقیقات تولید می باشد.

طراحی و برنامه نویسی : یکتاوب افزار شرق

© 2024 CC BY-NC 4.0 | International Journal of Industrial Engineering & Production Research

Designed & Developed by : Yektaweb