Volume 19, Issue 5 (IJES 2008)                   IJIEPR 2008, 19(5): 83-87 | Back to browse issues page

XML Print

1- , sedighi@iust.ac.ir
Abstract:   (4994 Views)

Along with increasingly development of CAD/CAM software and their application in various industries, minimizing of the machining time is found to be more important. In this paper, firstly the concerning subjects are discussed regarding classification of the optimization techniques. These are programming techniques, high speed machining techniques and feed rate optimization techniques. As a case study, an NC code was generated for machining of a plastic die by means of a dedicated software and the die was machined conventionally. Then the workpiece was machined using optimization techniques. Finally times taken for two approaches have been compared. The result shows machining time after optimization has been reduced considerably (64%).


Full-Text [PDF 211 kb]   (3365 Downloads)    
Type of Study: Research | Subject: Other Related Subject
Received: 2010/07/19 | Published: 2008/07/15